THROTTLE CUT
In addition, verify that the throttle link is not tightened or that the servo is not overloaded.
Interface path: HOME/MON. → [MODEL MENU] → [THROTTLE CUT]
Safely and easily to turn off the engine. Throttle cut provides an easy way to stop the engine from
running. Generally speaking, it can be realized by dialing a hardware switch in an idle state. This function
cannot be triggered when the throttle is high to prevent any mis-operation. The position and direction of the
switch must be selected because the initial setting is [--].
The selected hardware cut switch adjusts the ratio value when the throttle and throttle lever are idle
down, until the engine can be completely shut down.
The set cut position
Current position of throttle stick
Control switch, default [--]
Place the stick on the throttle
position you want to hold with
Range 0%-50% and default
17% , click the value button or
the confirmation button to get
the position(POS)
Please pay attention to the throttle connection here, do not let the servo exceed the travel.
1 Status is switched to "ACT”
Cut position setting
3 Turn on the selected “cut control switch”, the engine stick is in the idle down state, adjust the rate until
the engine (motor) stops completely.
2 Click the “Switch” button to pop up the “Switch Assignment” interface and select the control switch.
Set the throttle trigger position
61
MODEL MENU \ HELICOPTER
DANGER
The "cut position" must not be
set higher than the lowest speed
throttle position. It is dangerous if the engine runs
at high speed.
