DUAL RATE
Interface path: HOME/MON. → [GENERAL MANU] → [DUAL RATE]
The function can set the rudder angle end point and action curve of CH1-CH8 channel, which can be
adjusted separately for each condition. This function is usually used after setting the servo stroke. When
mixing is applied from one channel to another, both channels can use the [Dual Rate] function to change
the operating ratio
Channel: CH1-CH8 channels can be set.
Mode: Flight conditions, switch, Two control modes. The "Flight Mode" mode is controlled by the
[General Menu] function setting switch.
1: Default curve, valid when other switches are
not activated. Can be set when other numbering
curve control switches are not activated.
Curves 1, 2, 3: The curve control switch can be
freely distributed, and the effective priority level is
the optimal level with large numbers (3 is preferred)
When the curve is set, the switch associated with other number needs to be deactivated, otherwise the
set curve will be the highest priority number curve that is activated.
4 Press the Back button to return to the [General Menu] menu and save the settings.
2 Enable the curve: switch SA hits the 2nd gear activation curve, and the curve activation indicates that
the arrow moves to the position number 2 (above).
Example of curve setting for the corresponding switch (setting the curve of the switch of 2):
3 Edit curve: The up and down keys switch to the curve setting interface on the second page to adjust the
curve (as shown below), and the curve associated with the adjusted SA is set.
1 Assign control switch: Select the “--” option under “2” in the interface (above), pop up the [Switch
Assignment] interface, select the control switch and select the active position. (For example, the 2nd
position of the switch SA is the active position: the upper and lower buttons select SA to press the confirm
button, the SA option flashes and jumps to the “switch” gear setting item, press the confirm button to open
the gear position setting, the up and down keys select the 2 gear position, press Confirm the key switch
activation condition is “On”, press the return key twice to save the settings and return to the [Dual Rate]
screen.)
Rate: The amount of rudder angle can be adjusted for
rudder angle.
EXP: Exponential curve, setting of the action curve.
When the negative value is near the neutral, it is slow,
and when it is positive, it is close to the parameter near
the neutral.
Rate: The action curve point position can be moved up
and down.
The Confirm key switch point and the left and right keys
to adjust the value.
The point position
Position 2 sign
48
GENERAL MENU