LINKAGE SETTING
LINK
Interface path: HOME/MON.→[LINKAGE SETTING]→[LINK]
The link function is used for matching the transmitter and receiver.
Telemetry: Data backhaul function. Mainly used for functional judgment and data analysis, shutdown
telemetry will affect the use of security functions. The default Telemetry is on, it is recommended to turn on!
Mode: Working mode selection(default working mode A). Please refer to the table on the right. The
channel marked in the table is defined as the default configuration. You can customize the channel by
[RECEIVER OUTPUT].
1 Successfully linked, and the receiver LED light
turns to solid green.
2 Connect to the servo, operate the transmitter,
when the corresponding servo has synchronous
output action it means link successfully.
4.Verify the Link method:
Link: Immediately link the transmitter and receiver.
Clicking link will bring up the confirmation box
Link steps (default working mode A)
1,Transmitter,enter into the menu [LINKAGE
SETTING] → [LINK], standby.
2,Charge the receiver, pressed SET button for 3
seconds, the LED orange light flashes.
3,Transmitter, the telemetry function is default,
click the Link of "Start" button, the RF light flashes.
Receiver
slot
Channel User defined
Model A
Model B
1
1
7
2
2
8
3
3
3
4
4
9
5
5
10
6
6
11
7
7
12
8
W
.
BUS
/
PPM
W
.
BUS
/
PPM
9
W
.
BUS2
W
.
BUS2
slot
Receiver Channel User defined
Model A/B
1
1
2
2
3
3
4
4
5
5
6
6
Receiver channel definition(Connect RF206S)
Receiver channel definition(
)
RF207S/09S
35
WARNING
When linking, please be careful
not to connect the power
equipment, and remove the propeller, pay attention
to safety! To ensure safety, please do not link in the
status where the motor and engine are running.
NOTICE
1. The transmitter and receiver
must be close to each other (less
than 1 meter);
2. The transmitter cannot perform link operation
in the simulator and student mode ([SYSTEM
SETTING] → [TRAINER] to set);
3. There is no other WFLY 2.4GHz system in
progress.
4. In the process of linking, if you need to exit the
link, click the“Cancel”button or press the Back
button.
5. After finished the link, the connection
verification must be performed.
6. Telemetry: Disabling this function when link
will affect the use of [RANGE CHECK] [LOW
BATTERY] [BUS SERVO SETTING]
[TELEMETRY],Etc.