MODEL TYPE
SYSTEM SETTING
Interface path: HOME/MON. → [SYSTEM
SETTING] → [MODEL TYPE]
Helicopter swash: H-1, HR3 (120°).
Model type: helicopter, airplane, multicopter
Wing Types (Airplane, glider):
Airplanes are available in 3 main wing types and 3
tail types. Helicopters can be chosen 2 swash types.
There is a default preset for each type of model data
2 Select "Helicopter" to bring up the swash list.
Example of operation: setting the model to
helicopter (HR3)
1 Select "MODEL TYPE" to pop up the model type
list.
When setting "MODEL TYPE", the selection interface will
pop up successively to complete the type selection.If you do
not select "ok" to save the operation and return to the parent
interface, the changes are not saved.
①
②
③
Save setting: After the type is selected, click the
“OK” button in the lower right corner to save the
settings.
- Wing: 1 aileron, 2 ailerons, delta wing
- Tail: Normal, V-tail, Ailvator; normal, winglet
(delta wing).
3 Select “HR3” to return to the default [MODEL
TYPE] interface, and click the“OK” button to save
the changes. Finish setting!
23
NOTICE
When the "MODEL TYPE" is
replaced
(
the data in current
model will be cleared!
) ,
the model data reset as
factory configuration of the new model. Therefore,
you must confirm that you do not need these data,
or use the [MODEL SELECT] function to "copy" the
backup of the model data, and then do the
replacement operation. Same as above, such as
"SWASH", "Wing Type" and "Tail Type" operation,
the corresponding operation will clear and change
the current model data to the default parameters of
the newly selected type, so it is necessary to reset
the model function of [SYSTEM SETTING] .
