Vicon RO-M EW, Руководство пользователя

Страница: 65 / 225

Before first use
65
Checking the
coupling shaft length
Put the machine on a supporting beam before moving in between
the tractor and machine
This will ensure that the machine cannot drop if the power lift should
inadvertently be operated while you are between the tractor and
machine. Without the support, a power lift that drops could wedge you
in, resulting in possible serious physical injury.
The length of the coupling shaft is checked and shortened after the
power lift is connected, but before the coupling shaft is connected.

Lift the machine with the power lift until the PTO shaft and the
machine drive axle are at the same height.
This is the shortest possible length between the two shafts.

Place the machine on a supporting beam.

Switch the tractor and the control box off, remove the key from the
ignition and engage the parking brake of the tractor.

Pull the coupling shaft apart into two halves.

Mount the loose tractor section of the coupling shaft to the tractor
PTO shaft.

Attach the loose machine component of the coupling shaft to the
drive axle of the machine.

Manually move the two coupling shaft halves next to each other.

Check the length and adjust it as described in the section below.
Shortening the coupling
shaft
The profiled tubes must overlap to the extent possible, with a minimum
of 150 mm.
The profiled tubes must however have at least 25 mm free clearance
at the outer edges when the tractor PTO shaft and the machine drive
axle are at the same height.

Shorten the two profiled tubes until 25 mm of clearance is
achieved.

Deburr both ends.

Clean the coupling shaft.

Shorten the protection sleeves by the same length.

Slide the coupling shaft halves into each other.

Connect the coupling shaft to the machine and tractor.

Lift the machine with the power lift to the highest operating position.