Vicon RO-M EW, Руководство пользователя

Страница: 211 / 225

Troubleshooting
211
Troubleshooting
Troubleshooting
table
Problem Possible cause Solution Pag.
Incorrect
application
rates (kg per
hectare)
Dosing setting incorrectly set Check the dosing setting 133
Incorrect setting for fine application
Set the dosing setting for fine application
as per the instructions
115
Driving speed signal not correctly set
Set the correct source of the driving speed
signal in the control system, as well as the
control box
77
Incorrect driving speed signal Calibrate the driving speed
Incorrect distance between the driving
tracks Always set out the driving tracks before
spreading
156
New type of fertiliser spread with the
same settings as the previous type.
Quality varies greatly between types Determine the characteristics of the
fertiliser, look for the relevant spreading
chart and set the spreader again 100
105
The flow of the fertiliser is blocked
Clean the machine thoroughly after each
use. Replace the agitator if it is worn out
177
Dosing setting and flow rate not entered
on the ‘Curve Calibration’ screen before
starting work activities
Find the correct values in the spreading
chart and enter them
112
Incorrect application rate and/or working
width entered Enter the correct application rate and
working width in the control system.
105
The control system is being operated
manually, so it does not perform
automatic calibration
Switch to automatic operation
Incorrect values entered after a manual
calibration test at a manually entered
application rate
Perform the calibration test in the correct
manner and enter the result obtained 123,
119
The speedometer is incorrect or not
measuring. Check the sensors and cables and
calibrate the wheel sensor or radar
51
For a tractor without driving speed
measurement: the simulated and real
driving speeds do not correspond
Adjust the simulated driving speed on the
main screen or the real driving speed
51
Difference
between the
flowrate on the
left and the
right spreading
discs
Dosing setting or discharge points are not
set the same
Check the settings 105
The stop of one or both of the actuators
have been moved Check the position of the connecting
points and readjust them
191
Discharge on one side is blocked
Clean the machine thoroughly after each
use. Replace the agitator if it is worn out
177