Vicon RO-M EW, Руководство пользователя

Страница: 155 / 225

Use in the field
155
Last setting check
A check list is given below, as well as in the jacket of the spreading
chart.
Do this last check to ensure good spreading results.
Are you working with the correct settings from the correct
spreading chart, based on:
•
distribution,
•
similar weight,
•
type of fertiliser,
•
desired working width,
•
desired driving speed?
Did you set the spreader in the correct way?
Did you:
•
set the height over the ground or crops to 75 cm?
•
is the spreader set horizontally at 4º or 8 º?
•
are the vanes mounted with the correct length?
•
are the correct number of dosing holes opened (fine application)?
•
is the correct discharge point set?
•
is the correct application rate set?
•
is the TrimFlow or border spreading plate in the transport setting
(or working setting)?
Did you check the following settings:
Did you:
•
have you checked the control system settings?
•
perform a tray test to check the spreading pattern?
•
calibrate the driving speed sensor on the site?
Are you working correctly:
•
Did you set the correct PTO shaft rpm?
•
Are you driving at the correct driving speed?
•
Did you set the tramlines at the correct distance?
•
Is the wind speed too high?