Vertiv SmartRow DCR, Инструкция по установке и эксплуатации

Страница: 47 / 102

2. Install the factory-supplied lobster claws in the rectangular cutouts, 1 on each side of the
plenum (2 in the front and 2 in the rear of the plenum).
3. Repeat steps 1 and 2 for each Top Plenum-Rack in your system.
NOTE: Run High-voltage power whips in the front of the row. Run Ethernet and other network cabling
in the rear of the row.
Figure 4.30 Lobster-claw installation (power whips not shown)
NO. DESCRIPTION
1 PDU plug
2
Rectangular cutouts
(2 in front and 2 in rear of plenum, 4 total)
3 Lobster claw installed
4.14.2 Routing Power Whips
Route power whips on the front of the row.
1. Locate the Rack/PDU Circuit breaker in the Load distribution center, Figure 4.31 on the next
page.
2. Identify the field-supplied power-cable whip and refer to Figure 4.31 on the next page:
a. At the start or end of the DCR row, connect the whip to the PDU plug (shown in Figure
4.30 above).
b. Route the whip through the (2) front-side lobster claws of each of the Top Plenums-Rack.
c. Punch-out the knockouts in the top of the Control Panel & Fire Suppression system.
d. Attach whip to he Rack/PDU Circuit breaker in the Load distribution center in the
Control Panel & Fire Suppression system.
Vertiv | SmartRow DCR Installer/User Guide | 47