Vertiv SmartRow DCR, Инструкция по установке и эксплуатации

Страница: 61 / 102

7 DCR CONTROL PANEL AND FIRE SUPPRESSION SYSTEM
The SmartRow DCR must be installed in compliance with all applicable national, state and local fire codes.
An emergency power off (EPO) switch is provided as one means of meeting regulations. Additional field-
supplied connections to the system may be required, depending on the applicable regulations, the
equipment configuration and the user’s operational preference.
The DCR Control Panel and Fire Suppression System has been fully tested and certified at the factory.
The DCR Control Panel and Fire Suppression System is shipped with wiring that, if required by local fire
code, must be field-connected to the shutdown circuits of the Liebert PDX/PCW and any connected UPS
systems.
Under NFPA regulations, systems protected by a clean fire-suppression agent can be left with the UPS
and HVAC systems operational at the discretion of the owner and local fire officials.
The DCR Control Panel and Fire Suppression System should be field-connected as a separate zone to the
building fire detection and alarm system.
If the SmartRow DCR is installed in a dedicated room, an additional strobe and horn may be installed at
the entrance to the room. Contact your local authorized service representative if required.
7.1 DCR Control Panel and Fire Suppression System Component Locations
Figure 7.1 DCR Control Panel and Fire Suppression System, exterior features
NO. DESCRIPTION NO. DESCRIPTION
1 Control-power available light 4 Manual fire-suppression release button (key-opened)
2 Fire-suppression-system abort button 5 Viewing window (for fire-system status LEDs)
3 Emergency power-off button 6 Horn and strobe
Vertiv | SmartRow DCR Installer/User Guide | 61