Vertiv SmartRow DCR, Инструкция по установке и эксплуатации

Страница: 26 / 102

10. Remove the panel on the rear of the Base plenum–PDX/PCW.
11. Locate the Liqui-tect Sensor cable tied to the PDX/PCW EC-motor impeller wheel, cut the
cable ties, and place the Liquitect 410 sensor in Position 2 (shown in Figure 4.10 on page 24).
12. Remove 2 of the 8-18 x ½” self-driller screws from the pump components box, and screw the
LT410 sensor into Position 2.
13. Re-position the condensate pump right-side up and place it against the condensate-pump
bracket in Position 1 (installed in step 5 and shown in Figure 4.10 on page 24).
14. On the left-hand side of the PDX/PCW, un-clamp the rubber drain line from the drain-line
bracket.
15. Remove the clamp-hose wire from the pump-components box, slip it onto the drain line, and
insert the rubber drain line on to the barbed end connection of the condensate pump. (See
Figure 4.12 on the facing page for proper positioning.)
16. Re-clamp the drain line to the drain-line bracket referenced in step 14.
17. Remove the 90° compression fitting elbow (105) from the pump components box and install it
onto the ½-in. Copper drain line that routes to the top of the unit. (See Figure 4.12 on the
facing page for proper positioning.)
18. Remove the ½” tube form (106) from the pump components box. Install the tube form into the
90
⁰
compression fitting on the condensate pump. (See Figure 4.12 on the facing page for
proper positioning)
19. Remove the remaining condensate-pump bracket (107) and two 8-18x1/2” self driller screws
(108) from the pump-components box, position the bracket against the condensate pump, and
screw the bracket into Position 3 (shown in Figure 4.10 on page 24) using the self-driller
screws.
Vertiv | SmartRow DCR Installer/User Guide | 26