Vertiv SmartRow DCR, Инструкция по установке и эксплуатации

Страница: 25 / 102

8. Use pallet jacks or a similar lifting device to place the PDX/PCW on the Base Plenum-PDX/PCW
so that the iCOM display is facing 180 degrees from where the DCR Control Panel and Fire
Suppression system will sit (See
Components of single Liebert PDX/PCW system installation on
page 15).
The PDX/PCW must be aligned with the back of the base plenum that supports it. The
PDX/PCW also should be flush with the side of the DCR Base Plenum-PDX/PCW.
WARNING! Risk of personal injury. Can cause equipment damage, injury or death. The Liebert
PDX/PCW weighs more than 600 lb. (272 kg). If a lifting device is used to move the PDX/PCW,
ensure that it is rated to handle its weight. If personnel will move the unit manually, ensure that
an adequate number of properly trained and qualified personnel are used. Read all instructions
before beginning.
WARNING! Make sure that the Condensate Pump is laying on its side to ensure that the pump
does not get cracked or damaged during the installation of the PDX/PCW unit.
WARNING! Risk of top-heavy unit falling over. Improper handling can cause equipment
damage, injury or death. Only properly trained and qualified personnel wearing appropriate
safety headgear, gloves, shoes and glasses should attempt to move, lift, remove packaging
from or prepare unit for installation. Read all instructions before attempting to move, lift,
remove packaging from or preparing unit for installation.
9. Locate the hole(s), shown in Figure 4.11 below, in the bottom of PDX/PCW, and insert the four
supplied carriage bolts (3/8”-16 x 1-1/2”). Then from underneath the base-plenum, install
and tighten the hex nuts and washers.
Figure 4.11 Secure the Liebert PDX/PCW to the DCR Base Plenum-PDX/PCW
NO. DESCRIPTION
1 Hole (in each corner)
Vertiv | SmartRow DCR Installer/User Guide | 25