Vertiv SmartRow DCR, Инструкция по установке и эксплуатации

Страница: 71 / 102

9 START-UP
9.1 System Start-up and Commissioning
The Thermal Management components will be started-up by Vertiv™ personnel.
Authorized Fire
Suppression Personnel will contact the user to schedule start-up and commissioning. Optional UPSs will
be started-up and commissioned by authorized service personnel if the UPS start-up option is purchased
by the user.
The initial start-up should be scheduled after all installation steps have been completed.
NOTE: The DCR Control Panel and Fire Suppression System is shipped from the factory with the
solenoid activator disconnected and without the nozzle placed in the supply air stream. The fire-
suppression system should be commissioned after the UPSs, Rack PDUs and Liebert PDX/PCW have
been commissioned and are fully operational.
9.2 System Start-up and Activation
The SmartRow DCR is configured to start-up when power is connected. The user must connect the
emergency fans and the SmartRow DCR Control Logic to an on-line double-conversion UPS power source.
We recommend that the DCR Fire-suppression Controls and the DCR Control Circuit are supported by an
on-line double-conversion UPS. When power is fed to the SmartRow DCR, the Control Power available light
should be illuminated (green) on the front door (See Table 7.1 on page 63).
Vertiv | SmartRow DCR Installer/User Guide | 71