Vertiv SmartRow DCR, Инструкция по установке и эксплуатации

Страница: 16 / 102

4.1.2 Configuring the SmartRow DCR for Left-to-Right Assembly
These steps are only needed if you have a single thermal-management-unit configuration and you want
to mount the unit and the Control Panel and Fire Suppression system on the left-hand side of the
SmartRow assembly. You are modifying the base and top plenums for the control panel/thermal-
management unit for installation on the opposite end of the SmartRow.
1. Modify the Base Plenum-PDX/PCW (DCR-A-300 PDX):
a. Remove the cover plate on the right-hand side of the Base Plenum-PDX/PCW, and set it
aside to be installed on the base plenum of the final rack on the opposite end of the row.
b. Move the (2) Back-draft Dampers on the left-hand side of the plenum to the right-hand
side of the plenum as shown Figure 4.2 below.
c. Move the (4) Hex stand-offs from the left-hand side of one of the Base Plenums-Rack
(DCR-A-101) and install them on the right-hand side of the Base Plenum-PDX/PCW
(DCR-A-300PDX), see Figure 4.2 below.
The Base Plenum-Rack without the stand-offs is now the base plenum that will be
positioned on the opposite end of the row with the cover plate installed on its right-hand
side.
Figure 4.2 Modifying Base Plenum-PDX/PCW for installation on left-hand side of SmartRow
NO. DESCRIPTION NO. DESCRIPTION
1 Cover plate 4 Base plenum-PDX/PCW after modification
2 Back-draft dampers 5 Base plenum-PDX/PCW before modification
3 Hex stand-off hardware (4 places)
Vertiv | SmartRow DCR Installer/User Guide | 16