Vertiv SmartRow DCR, Инструкция по установке и эксплуатации

Страница: 21 / 102

10. When the complete base plenum assembly is level, use the 3/4” (19-mm) wrench to tighten the
jam nuts against the bottom of the plenum assembly to secure the leveling feet, Figure 4.7
below.
Figure 4.7 Level plenum using carpenter’s level and wrench to adjust and lock feet
NO. DESCRIPTION
1 Carpenter’s level
2 Jam nut
3 Height-adjustment nut
11. Tighten all internal plenum Nylock nuts installed in step 5 using an M10 socket.
NOTE: Floor anchoring, if required, should not be done until after all steps above have been completed.
Floor anchoring is optional. Hardware for this step is not included. For further information, contact
your local Vertiv™ representative.
4.4 Set the PDX/PCW on the Base Plenum-PDX/PCW
and Install Condensate Pump and Liqui-tect Sensor
There is factory-installed gasketing around the perimeter of the top face of the DCR Base Plenum-
PDX/PCW. The PDX/PCW will rest on the area highlighted in Figure 4.8 on the next page. The Liebert
iCOM screen must face the opposite side of where the DCR Control Panel and Fire Suppression System
will sit,
see Figure 4.8 on the next page.
NOTE: Take care not to damage the gasket when setting the PDX/PCW and the Control Panel and Fire
Suppression System on the Base Plenum.
Vertiv | SmartRow DCR Installer/User Guide | 21