Vertiv SmartRow DCR, Инструкция по установке и эксплуатации

Страница: 19 / 102

2. Check the DCR Base Plenum-PDX/PCW installation position to ensure that it meets the
required clearances; refer to Clearance Requirements on page 13.
NOTICE
Risk of severe cabinet and system stress. Can cause equipment damage and improper
operation.
Do not move the SmartRow DCR after assembly. This unit is not designed to be moved after
assembly. Movement without properly disassembling the SmartRow DCR can damage internal
components, reduce unit stability and void the warranty.
Floor anchoring, if required, should not be performed until after the entire base plenum
assembly has been completely assembled and leveled.
3. Remove the plenum side plate cover attached on the interior of the Primary DCR
Base Plenum-PDX/PCW (DCR-A-300PDX). This will be installed on the last base plenum in the
row.
4.3 Assemble the DCR Base Plenums-Rack
The base plenum-rack assembly supports the SmartRow DCR and distributes supply air to the DCR
Racks.
1. Apply the factory-supplied, D-shaped gasket material to the side of the DCR Base Plenum-
Rack that faces the DCR Base Plenum-PDX/PCW as shown in Figure 4.5 below.
• The gaskets are cut to the correct length at the factory.
• The gasket must be applied continuously along the profile edge of the plenum frame.
• Apply pressure to the gasket to make sure it adheres to the frame.
2. At each corner, form a 1-in. to 1.5-in. radius, Figure 4.5 below.
3. When you reach the starting point, form a sealed joint by butting the start and finish edges
together, Figure 4.5 below.
Figure 4.5 Gasket applied to side of base plenum
NO. DESCRIPTION
1 Gasket 1-in. to 1.5-in. corner radius
2 Gasket start and finish
Vertiv | SmartRow DCR Installer/User Guide | 19