SmartSensor V
www.wavetronix.com
801.734.7200
QUICK START GUIDE
1
Ensure that all necessary components are available
You will need a number of items in order to install your sensor, including but not limited to the items below:
˽
Mount bracket and Band-It clamping system
˽
Sensor cable and homerun cable
˽
Click equipment and pole-mount box
˽
Laptop with SmartSensor Manager, downloaded
from wavetronix.com
˽
Bucket truck
2
Select a mounting height
Use the table to select the mount-
ing height for the sensor based on
the offset from the nearest detec-
tion lane. The range of ideal offsets
is highlighted in gray. If possible,
use the height contained in the
second column (Recommended
Mounting Height).
In areas with a lot of truck traffic,
consider a higher mounting height
to help mitigate occlusion.
Note.
This table is truncated. For a
complete table, refer to the
Smart-
Sensor V User Guide
.
Offset from first
Detection Lane
(ft/
m
)
Recommended
Mounting Height
(ft/
m
)
Minimum
Mounting Height
(ft/
m
)
Maximum
Mounting Height
(ft/
m
)
9
/ 2.7
12
/ 3.7
9
/ 2.7
15
/ 4.6
15
/ 4.6
15
/ 4.6
12
/ 3.7
18
/ 5.5
20
/ 6
18
/ 5.5
15
/ 4.6
20
/ 6
25
/ 7.6
20
/ 6
17
/ 5.2
25
/ 7.6
30
/ 9.1
22
/ 6.7
19
/ 5.8
30
/ 9.1
35
/ 10.7
23
/ 7
20
/ 6
35
/ 10.7
40
/ 12.2
25
/ 7.6
22
/ 6.7
40
/ 12.2
45
/ 13.7
27
/ 8.2
23
/ 7
45
/ 13.7
50–80
/ 15–24
30
/ 9.1
25
/ 7.6
must be < offset
1
Attach the mount bracket to the pole using the straps.
2
Tighten the strap screws partway. The sensor alignment will need to
be fine-tuned later, so keep the straps slightly loose.
3
Attach the sensor to the bracket; the connector at the bottom of the
unit should point towards the ground.
4
Place the lock washers onto the bolts, thread on the nuts and tighten.
3
Attach the sensor and mount bracket to the pole
