ThermoFisher Scientific Vanquish VC-D50, Руководство по эксплуатации

Страница: 76 / 188

5 • Installation
Page 76 Fluorescence Detectors (VC-D50, VC-D51, VF-D50, VF-D51)
Operating Manual
1. Connect the waste line to the flow cell outlet (OUT) (1).
2. Route the waste line through the top recess (2) in the partition
panel.
3. Route the waste line through the tubing guides of the system
modules below the detector to the Vanquish system base (3).
4. On the system base, route the detector waste line through the
dedicated detector waste outlet to waste and connect the detector
waste line to the waste container as described in the
Vanquish
System Operating Manual .
TIP
The waste line should go straight to the system base and to waste. Make
sure that the line is positioned straight in the tubing guides.
5. If you have to cut tubing to length, use a tubing cutter. Make sure
that the cut is at right angle to the length of the line and that the cut
is not crimped.
6. Check the waste line over the entire flow path: Make sure that no
bending (kink), pinching or squeezing of the waste line is present at
any point in the flow path.
5.6.6 Guiding Liquid Leaks to Waste
Leaking liquids of the device are collected in the leak tray, where they
flow off through the chase on the right side of the leak tray to the drain
system.
For information about how the liquid is discharged to waste through the
Vanquish drain system, refer to the
Vanquish System Operating Manual .