ThermoFisher Scientific Vanquish VC-D50, Руководство по эксплуатации

Страница: 137 / 188

7 • Maintenance and Service
Fluorescence Detectors (VC-D50, VC-D51, VF-D50, VF-D51)
Operating Manual Page 137
Follow these steps
CAUTION—Hot surface
The flow cell may become hot. Touching a hot flow cell might cause
burns.
• Touch the flow cell briefly and carefully to find out if it is hot before
you remove the flow cell.
• If the flow cell is hot, allow the flow cell to cool down before you
remove it. Make sure the flow cell temperature control is turned off.
1. Disconnect the capillaries from the flow cell inlet and outlet.
2. Close the flow cell inlet and outlet with the flow cell plugs that were
installed when the flow cell was shipped.
3. Loosen the two flow cell screws until they are loose. The screws are
captive in the flow cell and do not need to be removed.
4. Remove the flow cell from the flow cell opening.
5. Install the flow cell cover to the flow cell opening. Tighten the two
screws finger-tight (no tools required).
Figure 36: Installing the flow cell cover
No. Description
1 Flow cell cover screws
2 Flow cell cover
NOTICE
The flow cell opening on the device is sensitive to dust and debris.
If no flow cell is installed to the device, close the flow cell opening with
the cover for the flow cell opening.
6. To store or ship the flow cell, place it in its packaging.