TANDBERG SM6610, Справочное руководство

Страница: 20 / 200

Introduction
Page 1-12 Reference Guide: SM6610, SM6615, SM6620 and SM6625 Satellite Modulators
ST.RE.E10152.2
1. Switch on the Modulator. With the Modulator correctly installed and
connected to the input and output equipment, switch on the unit in
accordance with the instructions given in Chapter 2, Installing the
Equipment. Confirm that it powers up correctly. If it does not, refer to
Chapter 8, Preventive Maintenance and Fault-finding.
2. Establish local or remote control. Connect the relevant terminal to the
RS-232/485 port or the Ethernet Port (1 or 2). Ensure the terminal is
switched on and operational (see Chapter 3, Operating the Equipment
Locally for instructions on how to establish control from the local
terminal or from the remote terminal).
NOTE…
The rear panel connector is compatible with either RS-232 or RS-485, depending upon the mode
selected on the Modulator. (See Section 3.7 System Menu, Option 4, Serial Port Configuration. )
3. Select configuration parameters. Set the required configuration
parameters (see Chapter 3, Operating the Equipment Locally for
instructions on how to select parameters from the local terminal).
4. Implement the configuration. Ensure the required configuration
parameters are sent from the terminal to the Modulator and that they
are implemented.