Tadano GR-1600XL, Руководство по обслуживанию

Страница: 82 / 269

68
WY05-5020E
Y-7 Y-7
Assembly Adjustment (Traveling Device)
3. Engine speed
[NOTICE]
Before checking the engine speed, run the engine
to warm it up. (Torque converter oil temperature
should reach approximately 50°C (122°F).)
1. No-load Max. speed
• PTO - OFF : 2860 ± 40 min
-1
• PTO - ON : 2150
+50
– 0
min
-1
(Eco mode - OFF)
2. Idling speed : 670 ± 25 min
-1
(PTO - OFF)
3. Stall speed
(1) Set the switches and levers as described below.
• PTO switch : OFF
• Shift lever : 2nd gear
• Drive speed selector switch : 4WD High
• Service brake : Applied
(2) While depressing the brake pedal, depress the
accelerator pedal all the way. Check the engine
speed.
Max. speed standard when stalled:
Approximately 2160 min
-1
(for reference)
4. Retightening the hub nuts
• Retighten the hub nut with the tightening torque of
640 ± 30 N-m (65 ± 3 kgf-m) (472 ± 22 ft-bf).
• Put the retightening torque for the hub nuts (the
torque of the latest tightening) on the hub nut
torque check record.
5. Adding oil to the torque converter and
transmission
[NOTICE]
When checking the oil level, turn PTO OFF and turn
the air conditioner OFF. Check at an oil temperature
of 50°C (122°F), once the oil level has stabilized
after the engine is started.
Do not add too much or too little oil.
Do not allow dust or water to enter when adding oil.
1. With the engine stopped, add oil to the oil injection
port in the top of the T/C, to the prescribed level
on the T/M oil level gauge.
2. Put the T/M in neutral and start the engine. While
idling (670 min
-1
), continue to add oil. Check that
the oil level has stabilized within the range
indicated by the * mark on the T/M oil level gauge.
Total oil volume:
approx. 37 L (9.8 gal)