T-Comfort 930 DSL, Руководство пользователя

Страница: 26 / 152

24
Installation Installing an Expansion Set
Installing the power supply for the expansion module
5. Place the power supply to the right of the expansion module. Carefully press the power supply into the
mounting recess provided (shown in the diagram as “1”). Move the power supply forwards until it snaps
into place in all six pressure terminals (“A”, “2”).
6. Connect the power supply output (flat conductor cable) to the appropriate jack of the expansion module.
Insert the fully insulated connector of the mains supply in the power supply connection provided.
7. Establish an Ethernet connection between the LAN port of the basic module and the LAN1 port of the
expansion module (see also Positions of the Ports starting on page 30). To do this, use the short Ethernet
connection cable from the expansion set. The LAN0 port of the expansion module is intended for con-
nection to a corporate LAN. You can connect an existing Ethernet connection cable to the LAN0 port of
the expansion module.
You usually install at least one interface card on the expansion module. To do this, read the instructions in the
following section.
S
Please note: Two power supplies are provided for the T-Comfort 930 DSL with an ex-
pansion module. Always turn on the power supply of the expansion module first and
then plug in the plug-in power supply.
1. 2.
A