Stone Rhino 43 Series, Руководство оператора, Страница: 29 / 66

2
Operation
Rhino
TM
43/54
2. Only remove filler cap when cool enough to touch with bare hands. Slowly
loosen cap to first stop to relieve pressure before removing completely.
3. Remove cap, coolant level should just touch the bottom of radiator filler neck.
If coolant is required, see “Adding Coolant” in the Maintenance section of this
manual.
IMPORTANT: Do not overfill radiator. Refer to “Coolant Maintenance” if
additional coolant is required. Never pour cold liquid into a hot engine, as
it may crack cylinder head or block. DO NOT operate engine without coolant
for even a few minutes. If coolant leaks or abnormal temperature is detect-
ed, contact a service technician immediately.
NOTE: It is normal for a small amount of leakage to occur as the engine
cools down and parts contract. Excessive coolant leakage may indicate the
need to replace the water pump seal. Contact your engine distributor or
servicing dealer for repairs.
TIRES/lUG NUTS
Do not exceed rated pressure 35 psi.
Clean and check daily:
1. Tires are properly inflated.
2. Lug nuts are in place and tight 190 ft. lbs. (140 Nm).
DRUM/SCRAPERS
Clean and inspect daily to prevent excess mud and debris from building up. Replace if
missing or worn. Pad drum scrapers are adjustable, see Maintenance section.
ClEANING
Dirt and mud built up will reduce machine performance and/or cause failures.
Use pressurized water to remove dirt and mud. Clean and inspect entire machine daily.
Use extra care when cleaning radiator and oil cooler.
When cleaning machine, caution should be used around alternator area. Direct spraying
of the alternator is not good. (Alternator should be covered or protected if direct spray-
ing will happen). Excessive water pressure may also loosen wire connections or start
terminals corroding. After cleaning, all terminals should be dried if wet and connections
checked for proper seating.
ECCENTRICS
When vibratory compaction is necessary, engage eccentrics by pushing the vibe but-
ton . For best performance run engine at full rpm. The eccentrics should be turned off
whenever the roller is stopped or stopped to change direction. Do not run the eccentric
on any non-yielding surface such as concrete or aged asphalt.
WARNING
WARNING