Spraying Systems Co 1550+ AutoJet, Руководство пользователя

Страница: 15 / 86

15

Power input connection, route power cord through oval opening on right-hand side of frame and plug in 120VAC
outlet rated for at least 5A.
From bottom to top.

Remote current “4-20 mA” analog input connections.
o
To be connected if using remote set point PWM controls, (analog 4-20mA).
o
M8 (F) 4 pin connection.

Electric spray nozzle output connection “Main” electric spray nozzle connection.
o
M12 (F) 4 pin connection.

Trigger input connections “Trig”
o
For remote triggers or digital sensor inputs, connected at installation
o
Follow the installation instructions for the sensor you have.
o
M12 (M) 4 pin connection.

Trigger interlock connection “T. int.”.
o
M8 (M) 4 pin connection.
o
Used when a secondary run signal is required.
Control Panel Only Versions
All the connections are the same as the full system. Located on the bottom of the panel the connections are as follows.

Power input connection, route power cord through oval opening on right-hand side of frame and plug in 120VAC
outlet rated for at least 5A.

4-20 mA - Analog input is accessible through this connection.

Main - Output is the connection for all electric spray nozzles or cylinder/atomizing air solenoids and fault output.

Trig - Is the input connection for the system trigger or sensor.

Aux - Is the output connection for the atomizing and fan air solenoids. This is typically not used in this
configuration, since solenoids are not provided.
 T. int. – Used for the optional trigger interlock or level switch input.