Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/597 B
©
Sony Ericsson Mobile Communications AB
88(113)
Step-by-Step Instructions
6.
Orient the antenna assembly so that the rear speaker
cavity is away from you and the antenna loop is to
the top.
7.
Remove the protective backing from back of the
contact portion of the speaker assembly’s flex film.
8.
Orient the contact portion of the speaker assembly’s
flex film over the lower left corner of the antenna
assembly so that the features of the contact portion
of the rear speaker assembly correspond to the
alignment features on the antenna assembly.
9.
Place the contact portion of the speaker assembly
onto the antenna assembly and apply pressure so that
a good bond is formed between the two parts.
NOTE! The rear speaker should extend off to the left
side of the antenna assembly if the contact
portion of the speaker assembly has been
correctly positioned.
10.
Remove the protective film from the adhesive ring
attached to the speaker.
11.
Wrap the rear speaker assembly’s flex film around
the side of the antenna assembly and insert the
speaker into its cavity.
12.
Apply pressure to the back of the speaker so that a
good bond is formed between the speaker and the
antenna assembly.
•
Perform the Rear Speaker Cloth Installation Procedure
•
Perform the Antenna Assembly Installation Procedure
•
Perform sections 2.2.3 - 2.2.5 of the Base Reassembly Procedure
