Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/597 B
©
Sony Ericsson Mobile Communications AB
105(113)
Step-by-Step Instructions
NOTE! Avoid contaminating the adhesive on the
flex film directly opposite of the extension
that contains the vibrator contact pads.
2.
Orient the main flex film so that the extension that
connects to the circuit board is to the top and the
circuit board connection on the flex film is facing
away from you.
3.
Rotate the circuit board extension of the main flex
film away from you and back around to the left side
of the flex film 270 degrees so that a large spiral is
formed in the circuit board extension.
NOTE! The circuit board extension should spiral to
the left of the main flex film.
NOTE! The looped portion of main flex film’s
circuit board extension will be further away
from you than the rest of the main flex film
if the circuit board extension was spiraled
correctly.
4.
Slide the spiraled portion of the flex film inside the
hinge covering portion of the inner flip cover and
press vibrator contact portion of the flex film down
onto it alignment peg to hold the flex film in place.
5.
Press the vibrator contact portion of the flex film
against the inner flip cover so the adhesive on the
back side of the flex film directly behind the vibrator
contacts will bond to the inner flip cover.
