Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/597 B
©
Sony Ericsson Mobile Communications AB
90(113)
4.32.2
Receiver Installation
The receiver can never be reused. Therefore, if the receiver has been removed a new receiver must
be installed.
Tools needed to perform the following steps:
*
Pry tool
*
Style 2A ESD-safe tweezers (Blunt Tip)
NOTE! A “ * ” beside a tool listed above indicates that the tool is not specifically called out in the
following instructions, but an operator may find it helpful to use that tool when performing some
steps of the following procedure.
NOTE!
The phrase “pry tool” indicates that a nylon pointer, an orangewood stick, or a front opening tool
may be used during this procedure depending on the user’s preference.
Step-by-Step Instructions
1.
Apply an adhesive ring to the side of the receiver
that has the circular pattern of holes. The adhesive
ring should be applied so it is positioned between the
ring of holes and the outer edge of the receiver.
2.
Remove the protective covering from the receiver’s
adhesive ring.
3.
Orient the receiver so that its side with the adhesive
ring attached is towards the receiver cavity in the
LCD sub-frame and the alignment tab on the receiver
is aligned with the corresponding notch in the side
wall of the receiver cavity.
