Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/597 B
©
Sony Ericsson Mobile Communications AB
107(113)
Step-by-Step Instructions
NOTE! Make sure that the black retaining bar on the
main flex film’s camera module connection
is rotated towards the center of the
connector into a vertical orientation before
trying to insert the mating flex film.
10.
Carefully slide the flex connection of camera module
into the slot in the edge of its mating connector on
the main flex film. Slide the two halves of the
connection together until the two tabs on each side of
the camera module’s flex film are butted against to
the edge main flex film’s connector.
11.
Rotate the black retaining bar away from the camera
module’s flex film into a horizontal orientation.
Then press down on the retaining bar to make sure it
is completely closed.
•
Perform the Hinge Reassembly Procedure
•
Perform sections 3.2.2 - 3.2.3 of the Flip Reassembly Procedure.
•
Perform the Antenna Cover Installation Procedure.
•
Perform sections 2.2.2 - 2.2.5 of the Base Reassembly Procedure.
