Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/597 B
©
Sony Ericsson Mobile Communications AB
93(113)
4.33.2
Side Key Flex Film Installation
If this part is being replaced, a new part should be used in the place of the old part when
performing the following steps.
Tools needed to perform the following steps:
*
Pry tool
NOTE! A “ * ” beside a tool listed above indicates that the tool is not specifically called out in the
following instructions, but an operator may find it helpful to use that tool when performing some
steps of the following procedure.
NOTE!
The phrase “pry tool” indicates that a nylon pointer, an orangewood stick, or a front opening tool
may be used during this procedure depending on the user’s preference.
Step-by-Step Instructions
1.
Orient the circuit board so that the dome foil is
towards you and the system connector is oriented to
the bottom.
NOTE! Make sure that the black retaining bar on the
circuit board connector for the side key flex
film is rotated to a vertical orientation
before trying to insert the connection
portion of the side key flex film.
2.
Orient the side key flex film so that the side of the
flex film with the dome foil is towards you and the
contact portion of the flex film is aligned with the
bottom of its connector on the circuit board.
3.
Carefully slide the connection portion of the side key
flex film into the slot in the edge of its mating
connector on the circuit board until the flex film will
not insert any further.