OK
OK
Turn
Press
OK
Press
7KLVGLVSOD\LQGLFDWHVWKDWFKDQJLQJD
UHDGRQO\YDOXHLVLPSRVVLEOH
Figure 6-27 Viewing a normal read-only parameter (example)
Note
The procedure to set an indexed editable parameter (Pxxxx[x]) is the same as shown in this
example.
The alternatives to change parameter values are the same as afore-described under Fig. 6-8,
but one exception is: if the value range available for setting consists of discontinuous values
(for example, for P0005), when you turn OK to appear a value that is not available for this
parameter and then press OK, an error indication ("Err- -") will appear indicating value setting
is impossible. Then, the display will automatically jump to the next immediately followed and
available-for-setting value.
Button/keys inactive in this mode
If the current connection macro selected is "C01xx" or "C05xx", the LOC/REM key is inactive
in this mode.
The STOP and RUN keys are active when one of the preconfigured connection modes is
selected and currently the command source is from the operator panel.
The OK button and the SET key are always active in this mode.
Long-pressed STOP key is always active.
6.7
Factory reset
Factory reset (P0970)
Proceed the following steps to perform a factory reset:
1. Stop the motor operation.
2. Go to the "Access all the parameters" mode, set P0970 to desired value (please refer to
below table).
Commissioning
6.7 Factory reset
SINAMICS V10
72
Operating Instructions, 08/2011, A5E03453178 (this is not an order number)
