Schweitzer Engineering SEL-2032, Инструкция по эксплуатации

Страница: 223 / 354

8.7
Date Code 20120126 Instruction Manual SEL-2032 Communications Processor
Serial Port Communications and Commands
Command Set
COPY m n
The COPY command (Access Level 2) copies all port-specific settings
including port (P), automatic message (A), data movement (M), user-defined
command (U), protocol card control (O), and logic (L) settings from Port
m to
Port n ( m and n equal any combination of 1
–
16). You can also copy between
Ports 17 and 18. Type COPY 1 ALL <ENTER> to copy Port 1 settings to all
other rear-panel ports.
Use SET to modify copied settings. Settings cannot be copied to any port that
is actively involved in transparent communications.
The SEL-2032 makes confirmations as shown in Figure 8.9 for each port to
which settings are copied.
*>> COPY 1 5 <Enter>
Copy settings from Port 1 to Port 5 (Y/N) ? Y <Enter>
Perform auto-configuration on Port 5 (Y/N) ? N <Enter>
Port 5 Settings Changed
*>>
Figure 8.9 COPY Command
If you copy to multiple ports using the ALL parameter, the confirmation is
repeated for each port.
If you copy settings having CONFIG=Y, the SEL-2032 asks if you want to
auto-configure the destination port. If you answer
N (No), the SEL-2032
assumes the devices connected to the two ports are identical. If you answer Y
(Yes), you may lose some auto-message settings on the destination port if the
connected device is not the same type as the device connected to the source
port.
When you use the COPY command, the SEL-2032 will make changes to port
numbers used in strings and in SEL
OGIC
control equations within the copied
settings based on the following rules: for the command format “ COPY n m ”,
any reference to Port n will change to m , and any reference to a port other than
n will remain unchanged. Always use the SHOWSET command to verify
settings following a copy. Use the SET command to make required
adjustments to settings.
The SALARM bit asserts for one second after a successful copy to indicate
that the settings have changed. In the SEL-2032, SALARM is assigned to
ALARM by default, so the alarm contact will close for one second unless this
setting has been changed.
If you copy settings to the current port, change your terminal’s communication
parameters to match once you accept the changes.
DATE
The DATE command (Access Level 1), without parameters, displays the date
stored by the internal calendar/clock. Use the DATE command with a date
parameter to change the date: DATE mm/dd/yy . For example, set the date to
March 20, 1994, as shown in Figure 8.10 .
Courtesy of NationalSwitchgear.com