Raymarine c125, Инструкция по установке и эксплуатации

Страница: 269 / 464

Depth data source
Where multiple sources of depth data exist on a
system and the depth Data Source is set to Auto the
system will automatically select the optimum source
for depth data.
The system will set the data source for depth
according to the priority table below:
1 st CP450C SeaTalk hs
2 nd CP300 SeaTalk hs
3 rd DSM300 SeaTalk hs
4 th
DSM30 SeaTalk
hs
5 th Traditional
sonar variant
multifunction
displays SeaTalk hs / internal
6 th DownVision TM
variant
multifunction
display
SeaTalk hs / internal
7 th CP100 SeaTalk hs
8 th
Instrument /
multifunction
display SeaTalk ng
9 th Instrument SeaTalk
10 th Instrument /
multifunction
display NMEA 0183
If multiple sonar modules of the same type are
present on a SeaTalk
hs network then the unit with
the highest serial number will be selected as the
preferred data source. For SeaTalk
ng and NMEA
0183 networks the unit with the highest CAN address
is selected.
If the preferred depth data source becomes
unavailable then the system will automatically select
the next highest priority data source.
Refer to the Data Source menu section for details on
selecting preferred data sources.
Important: A depth offset must be set for all
installed transducers to ensure consistent and
accurate data is shown. Refer to the
Depth Offset
section for details.
Note: SideVision TM cannot be used as a source
for depth data.
19.5 Sonar crosstalk interference
There are 2 types of potential sonar crosstalk
interference in a Raymarine sonar system:
1. SideVision sonar crosstalk interference
2. Multiple sonar crosstalk interference
The types of crosstalk interference that you
may experience in your system depend on the
combination and type of sonar equipment installed,
and the way in which the equipment has been
installed.
SideVision sonar crosstalk
interference Multiple sonar crosstalk
interference
Due to the high sensitivity
of
SideVision transducers,
you may experience some
minor crosstalk interference
between the left and right
receiving channels in areas
of strong target returns.
Examples of strong target
returns include solid objects
such as underwater bridge
structure. This interference
shows up in the Fishfinder
application as subtle
reflections from the right
sonar image displayed in
the left sonar image, or vice
versa.
When using multiple sonar
modules and transducers
operating in overlapping
frequency ranges, you may
experience some crosstalk
interference between the
ranges. This interference is
displayed in the Fishfinder
application as vertical “rain
drops” throughout the water
column. These vertical “rain
drops” indicate that 2 sonar
modules are operating in
close frequency proximity to
one another.
SideVision sonar crosstalk interference
Crosstalk interference is expected behavior in a high
sensitivity device such as a
SideVision transducer,
and is not indicative of a fault with your transducer or
sonar module.
Reducing multiple sonar crosstalk
interference
Crosstalk interference in systems with multiple sonar
modules and transducers is the result of a number
of factors, including installation, operation, and
environment.
• Choose an equipment combination that
minimizes overlapping frequencies.
Wherever
possible, choose to use sonar modules and
transducers that operate in different frequency
ranges (“Channels”), for example CP100 and
CP300 sonar modules and CPT-100 and B744V
transducers. This will help to ensure that each
component is operating in a distinct relative
frequency range – for example, a “high” frequency
range for the CP100 and a “low” frequency range
for the CP300.
• Only use the sonar channels that you really
need.
Although it is possible to run multiple sonar
Fishfinder application
269