Quantum SNC 4000, Руководство пользователя

Страница: 88 / 164

82 Service Port Command Reference
SNC4000 > fcPortModeSet 1
value = 0 = 0x0
fcRestart [port]
The
fcRestart
command restarts the specified FC port. You typically use this command to restart the port
after changing its configuration settings so that the changes take effect. Issuing this command is an
alternative to rebooting the SNC 4000 in order to make the configuration changes take effect.
The following example shows the display when the FC port is specified.
SNC4000 > fcRestart 1
value = 0 = 0x0:
Restart of FC Channel 1 succeeded
In order to get the command prompt (e.g.
SNC4000 >
) to show after you have executed the
fcRestart
command, you will need to press the Enter key.
fcShow [level]
The
fcShow
command displays the channel status for the FC interface.
Mode 1 Private Target
2 Private Initiator
3 Private Target and Initiator
17 Public Target
18 Public Initiator
19 Public Target and Initiator
CAUTION
You must issue the
fcRestart
command or reboot the SNC 4000 for
the new setting to take effect. See the
fcRestart
command for
further information.
CAUTION
This command interrupts traffic.
Parameter Value Meaning
Port 1 The SNC 4000 connection labeled FC1
Level Meaning
0 or
<blank> sets the verbosity level to the display in the example below
1 displays the information displayed below, and appends a break-out
for each channel that includes Node Type, Node Name, Port Name
and Port ID
Parameter Value Meaning