SNC 4000 User’s Guide
11
Getting Started
This section describes how to install and set up the SNC 4000, SCSI devices, and the Host Bus Adapter.
Installation is divided into four sections:
•
Unpacking and Inspecting
•
Pre-installation
•
Installation
•
Post-installation
Unpacking and Inspecting
Unpack the SNC from the carton. Check to make sure that the following items are included with your SNC
and that none of them are damaged:
•
One SFP
•
Product documentation and software CD-ROM
•
Two HD68/VHDCI SCSI cables
•
One LVD terminator
NOTE: Save the CD-ROM in a safe location for future reference.
Pre-Installation
It is important that the items in the steps below are verified before installation of the SNC begins. This
ensures a successful installation of the product.
Required Tools
Required Software
Other Resources
RS-232 straight through cable
ADIC Management Console
server/client software
IP information for the SNC
RJ-45 patch cable
SNC firmware
System with HyperTerminal
SC/LC fibre cables
Server to run ADIC
Management Console
Содержание SNC 4000
