Quantum SNC 4000, Руководство пользователя

Страница: 39 / 164

SNC 4000 User’s Guide 33
8 Perform the following:
• Start the ADIC Management
Console Server and Client.
• Log on with administrator
privileges.
• Connect to the SNC.
• If you downloaded new
operating software in Step 5 of
Updating the SNC on page 31,
update the firmware.
• Load the configuration file you
saved in Step 1 of Before
Removing or Replacing the
SNC
on page 28 into the SNC.
• Restart the SNC.
This step must be performed if you replaced the
SNC.
For more information, see the ADIC Management
Console User’s Guide .
9 Reconnect the FC cable or, if
you turned off the FC hosts, turn
them back on. If the FC LED for the attached host is not on, check
the FC cable.
You may have to change the polarity of the FC
cable. If the problem persists, go to
Start MAP on
page 42.
10 From the service terminal, enter
the
fcShow
command to show
the status of each FC interface
that is installed and connected.
From the service terminal, enter
the
fcShowDevs
command to
show the SCSI target devices
that are connected as seen by
the FC interface.
In the output of the
fcShow
command, look for the
Firmware State column.
If the word
Ready
does not appear, go to Fibre
Channel MAP on page 52.
Check to see that all SCSI target devices are seen
by the FC interface.
If not, go to SCSI Channel MAP on page 46.
11 Verify that all (or the designated)
target devices are available to
the host systems. If the designated devices are NOT available,
reboot the host and check again.
If the problem persists, go to Start MAP on page
42.
12 Disconnect the RS-232 cable
from the SNC and the service
terminal. None.
13 End of repair.
Table 2 Post-Repair Checklist
Step Actions Comments and References