18
Getting Started
2
From the HyperTerminal window, select
Transfer and Receive File
.
3
From the
Receive File
dialog enter the path to the folder where you want to save the file or click the
Browse
button and navigate to it.
4
For the
Receiving protocol
select
Zmodem
and press the
Receive
button.
5
Wait for the
Configuration Download Complete
status message to be displayed on the service
terminal indicating successful completion.
6
If HyperTerminal reports an error, try to receive the file again.
Loading a Configuration File
Follow the steps below to load a saved configuration file.
1
From the HyperTerminal window, at the
SNC4000>
command prompt, type
rz
and press
Enter
.
2
From the HyperTerminal window select
Transfer and Send File
.
3
From the
Send File
dialog enter the path and file name where the firmware file is located or click the
Browse
button and navigate to it. In the
Protocol
field, select
Zmodem
and click the
Send
button.
4
Wait for the
Configuration Update Complete
status message to be displayed on the service
terminal indicating successful completion.
5
Reboot the SNC for the update to take effect.
6
If HyperTerminal reports an error, try to send the file again.
Updating Firmware
You can upgrade the firmware on the SNC 4000 using the ADIC Management Console. For more
information, see the
ADIC Management Console User’s Guide
.
Содержание SNC 4000
