Panasonic EBL512 G3 5000, Руководство по планированию

Страница: 119 / 168

Panasonic Electric Works Nordic AB
MEW01351 Rev: - Planning Instructions Fire alarm system EBL512 G3, V1.1.x
117
17 Special New Zealand functions
NOTE! The functions in this chapter are valid for the New Zealand
convention only.
17.1 Alarm devices
17.1.1 Silence alarm devices (inside switch)
On the c.i.e. front, the button "Silence alarm devices" (see Operating
Instructions MEW01163, button "P2") is called the "inside switch"
and toggles between two states:

Alarm devices disabled
All programmable outputs of type "Alarm devices" are
disabled, i.e. they cannot be activated.

Alarm devices not disabled
All programmable outputs of type "Alarm devices" enabled,
i.e. they can be activated.
If the inside switch is in its disabled state when you are closing the
c.i.e. door the buzzer will beep once and the message "
Silence
switch left active "
will be shown in the display. This
message has lower priority than fire alarms but higher than other
disablements and faults.
NOTE! The inside switch has no function if the outside switch (see
below) is activated (on).
17.1.2 New Zealand FB Silence switch (outside switch)
The " New Zealand FB Silence switch " is called the "outside switch"
since it is placed outside the c.i.e. The outside switch is a key switch
and is connected to a programmable input with the trigger condition
"Silence alarms".
The outside switch is turned ON (i.e. from not activated to activated
state).

All programmable outputs of type "Alarm devices" are
disabled
115
, i.e. they cannot be activated. The "inside switch"
(see above) has no function.

LEDs "Fire" (on the c.i.e. front) changes from blinking to
steady (continuous).
116

The c.i.e. built-in buzzer is silenced.

A fault is generated
117
:
" FAULT: FB Silence switch
active, control unit xx
"
115
Indicated by LED "General disablements" on the c.i.e. front.
116
This is valid also if the fire alarm is activated after the outside switch is
turned on.