NTT docomo FOMA SO905i 07.11, Руководство пользователя

Страница: 300 / 470

298
Data Displa
y/Edit/Management
3
Enter the Security code and press (OK).
The Authentication password screen appears.
4
Enter the authentication password.
The screen for confirming whether to begin the infrared
communication appears.
5
Select [Yes] and press .
The infrared communication is started and data exchange
is started.
To cancel sending
Press (Cancel).
Sending a Still Image Using the High-
Speed Infrared Communication
You can send a JPEG image saved in My picture of
the Data Box or microSD memory card to the IrSS-
compatible devices using the high-speed infrared
communication.

IrSS is the one-way communication, so send data without
checking the answer from the receiver. Therefore, the sender
side is completed normally even if the receiver cannot receive
data.
Example: Sending an image in My picture of the Data Box
1
From My picture file list, select an image and press
(Func).
The Function menu appears.
2
Select [Send Ir data] → [Send IrSS] and press .
“ ” changes to “ ” and the screen for confirming
whether to begin the IrSS communication appears.
To send an image in the microSD memory card
Select [Send IrSS].
3
Select [Yes] and press .
The high-speed infrared communication is started and
data transfer begins.
After completing to send data, the screen informing the
completion appears.
4
Select [End] and press .
The high-speed infrared communication ends.
To send the same data again
Select [Retry].
Using the Infrared Remote
Control
Once infrared remote control software is downloaded
from a site and saved in the FOMA terminal, the FOMA
terminal can be used as the TV or DVD player remote
control.

To use the infrared remote control, it is necessary to download
the software corresponding to the target equipment. Even if
the corresponding software is used, some equipment may not
be operated.

The infrared remote control key operations vary depending on
the software.
■ Remote control operation
When using this function, point the FOMA terminal’s infrared
data port at the remote control receiver of the TV or DVD player
and operate the FOMA terminal within about 4 m remote control
range. Note that communication may be affected by the target
equipment or ambient brightness.
Within
about 4 m
Reception angle:
±15 degrees
off axis
Infrared data port
What is iC Communication
Function?
You can send and receive data by placing the FOMA
terminal provided with the iC communication function
over the FeliCa mark of another FOMA terminal.
 Data that can be sent and received by iC communication
i s t h e s a m e a s t h e d a t a e x c h a n g e d u s i n g i n f r a re d
communication (P.296).
 You cannot perform the iC communication during a call,
i-mode/packet/64K data/infrared communication, or when the
Lock all, Omakase Lock, Personal data lock, Self mode, or IC
card lock is set.
 To receive data using iC communication, make sure that the
FOMA terminal is in stand-by status. You cannot receive data
when operation of another function is in progress.
 During the iC communication, the status of the FOMA
terminal is the same as the outside of the service area status.
Therefore, you cannot place a call or perform i-mode and
data communication.
 Data may not be sent/received depending on the recipients’
terminals. In this case, move the FOMA terminals so that both
FeliCa marks “
” are closer or farther together, or move the
FOMA terminals ups and downs or back and forth.
 When you send mail data, all of the title may not be received
depending on the recipient’s terminal.