NF KP3000GS, Инструкция по эксплуатации

Страница: 228 / 279

8.1 Error Messages and Error Handling
KP3000GS 209
8.1.5 Error Message List
Error messages are listed in Table 8-2.
Table 8-2 Error Message List
ID Message Protection
type
Cause or Necessary action
2 Invalid in This Output
Mode Message
display only This output mode does not allow the setting
(execution). Change the output mode.
3 Invalid with Output ON Message
display only The output on state does not allow the
setting (execution). Turn the output off, then
set (execute).
4 Invalid with Output OFF Message
display only The output off state does not allow the
setting (execution). Turn the output on, then
set (execute).
5 Busy Message
display only The busy state does not allow the setting
(execution). Execute after the busy icon
disappears.
6 Invalid with Remote
Control Message
display only The remote control state does not allow the
setting (execution). Bring the state to local
control, then set (execute).
10 Sync Frequency Error Message
display only The external synchronization signal
frequency is out of the range, which does
not allow the setting (execution). Enter the
signal frequency within the range.
13 Auto Cal Disabled Message
display only The Autocal setting becomes off because of
out of the calibration range.
15 AGC Disabled Message
display only The AGC setting becomes off because of
out of the calibration range.
20 Invalid Message
display only The condition cannot be set (executed).
24 USB Memory
Unconnected
Message
display only No USB memory is connected. Connect a
USB memory.
25 USB Memory Removed
illegally Message
display only The USB memory was removed before the
eject operation. Perform the eject operation
before removing a USB memory.
26 USB Memory Access
Error Message
display only The USB memory has an access error.
27 Too Many Files Message
display only There are too many files in the USB
memory. Each folder can contain 500 files
or less.
29 Sync Frequency Unlocked Message
display only
The output cannot be turned on because of
not locking to the synchronization
frequency.
30 Remote Controller Error Message
display only Communication with the remote controller
cannot be made. Make sure the remote
controller cable is connected properly.
31 Internal Memory Error Message
display only The internal memory has an error.