NF KP3000GS, Инструкция по эксплуатации

Страница: 177 / 279

4. Advanced Operation
PROGRAMMABLE AC/DC POWER SOURCE 158
--------
Notes
------------------------------------------------------------------------------------------------------------
 You can enable/disable the external control function. When the external control function is
disabled, the input from the external control is not accepted, but the state output signal is output.
 We recommend that when the external control function is not used, the function is set to
disabled to avoid malfunctioning due to any exogenous noise.
 The external control input signal is ignored when the product is remote controlled via the
communication interface.
 The memory 1 and 2 inputs are the inputs for specifying the memory number. For No. 1 to No.
4 memory, specify the 2 bit memory number of the Basic Setting Memory in the Continuous
function, or of the Sequence Memory in the Sequence function, or of the Simulation Memory
in the Simulation function.
 When the memory recall input is changed from high to low, this loads the data of the Basic
Setting Memory in the Continuous function, or of the Sequence Memory in the Sequence
function, or of the Simulation Memory in the Simulation function which has the number
specified by the memory 1 and 2 inputs. For the Sequence and Simulation function, the
compile is also performed.
-----------------------------------------------------------------------------------------------------------------------------
Table 4-12 CONTROL I/O Pin Assignment
pin I/O Function Remarks
1 Output Power On/Off Low: Off, High: On
2 Output Output On/Off*
Low: On, High: Off (Negative)
Low: Off, High: On (Positive)
3 Output Protection operation*
Low: Active, High: None (Negative)
Low: None, High: Active (Positive)
4 Output Limiter operation*
Low: Active, High: None (Negative)
Low: None, High: Active (Positive)
5 Output AGC/Autocal setting state*
Low: On, High: Off (Negative)
Low: Off, High: On (Positive)
6 Output Software busy*
Low: Busy, High: Ready (Negative)
Low: Ready, High: Busy (Positive)
7 Output Output range Low: 200 V, High: 100 V
8 Output — Unused
9 Output Step sync code 1 (bit 0)
High level or Low level
(see Table 4-13)
10 Output Step sync code 2 (bit 1)
11 Output Trigger Positive or Negative
12 Output — Unused
13 Input Output Off Falling Off
14 Input Output On Falling On
15 Input Sequence start/resume Falling Start
16 Input Stop of sequence Falling Stop
17 Input Sequence is in the Hold status Falling Hold
18 Input Sequence branch 1 Falling Branch start
19 Input Sequence branch 2 Falling Branch start
20 Input Memory recall (+ compile) Falling Recall
21 Input Memory specification 1 Specify 0 to 3
(See Table 4-14, equivalent to memory 1
to 4, respectively)
22 Input Memory specification 2
23 Input Clear the current peak-hold value Falling Clear
24 — GND —
25 Reserved Do not connect anything Do not connect anything