NF KP3000GS, Инструкция по эксплуатации

Страница: 265 / 279

10. Specifications
PROGRAMMABLE AC/DC POWER SOURCE 246
10.27 External Interface
This is the interface to control the product from an external computer. The RS232 and USB
interfaces are provided by default, and either GPIB or LAN interface can be chosen when ordering.
(Both GPIB and LAN cannot be chosen.)
The command language is compliant with the SCPI Specification Version 1999.0. (Factory default
is USB).
USB interface (USB1.1) *43
Item Description
Device class USBTMC
ID Already assigned for each device
Terminator “LF”
*43: The use of USB hub may cause a communication failure. It is recommended to use a
fully-shielded, short cable.
RS232 interface *44 *45
Item Description or Selection Factory default
Terminal D-sub 9-pin (male, UNC #4-40 screw)
Baud rate 9600 / 19200 9600 bps
Terminator “CR” “LF” / “CR” / “LF” “CR” “LF”
Parity None/Odd/Even None
Stop bit 1 / 2 1 bit
Data bit 7 / 8 8 bit
Flow control None/Hardware/Software None
*44: Binary transmission is not supported.
*45: Use a cross cable.
GPIB interface (IEEE488.1 std 1987) *46 *47
Item Description or Selection Factory default
Address 0 to 30 2
Terminator “LF”
*46: Binary transmission is not supported.
*47: Query for the main unit status byte using a serial poll is not supported.
LAN interface (IEEE802.3, LXI 1.4 Core 2011) *48
Item Description or Selection Factory default
Terminal RJ-45 modular jack
Transmission method Ethernet(100BASE-TX / 10BASE-T)
Communication protocol SCPI-RAW
Terminator “LF”
IP address setting
Auto, Fixed Auto
*48: Binary transmission is not supported.