NEC Bull NovaScale R620 Series, Руководство пользователя

Страница: 292 / 346

NovaScale R620 User Guide
7-30
Problems with EXPRESSBUILDER
When the server is not booted from the EXPRESSBUILDER CD-ROM, check the following:

Did you insert the EXPRESSBUILDER CD-ROM during POST and restart the server?

If you do not insert the EXPRESSBUILDER CD-ROM during POST and restart the server, an error
message will appear or the OS will boot.

Is BIOS configuration correct?

The boot device order may be specified with the BIOS setup utility of the server. Use the BIOS setup
utility to change the boot device order to boot the system from the CD-ROM drive first.
<Menu to check: [Boot]>
When an error occurs while the EXPRESSBUILDER is in progress, the following message appears. After this message
appears, check the error and take the appropriate corrective action according to the error codes listed in the table below.
Message Cause and Remedy
This machine is not supported. This EXPRESSBUILDER version is not
designed for this server. Execute the
EXPRESSBUILDER on the compliant
server.
NvRAM access error An access to the non-volatile memory
(NvRAM) is not acceptable.
Hard disk access error The hard disk is not connected or it is
failed.
Check whether the hard disk is correctly
connected.
There is no device specific
information on motherboard.
Restore the backup information or
write the information using
[System Information Management]
in offline maintenance utility.
Only maintenance personnel can
operate this.
Are you going to run offline
maintenance utility? This message is displayed when
EXPRESSBUILDER cannot find device
specific information, such as when
replacing a motherboard.
Maintenance personnel write information
using offline maintenance utility.