NEC Bull NovaScale R620 Series, Руководство пользователя

Страница: 282 / 346

NovaScale R620 User Guide
7-20
module will not be separated. In this case, check each adapter setting referring to
“
After starting up, FT
Status LED do not light or lights amber
”
of this chapter.
Source: HasCtrl
Type: Warning
Event ID: 1505
Description: Device [Device name] is not duplexing.
[Device name]
“
LAN
”
or
“
SCSI
”
or
“
FC
”

When you attempt to disconnect IO module when the HAS Fault Tolerance service is not started, the
following message will be recorded to the system event log and the IO module will not be separated. In
this case, refer to
“
After starting up, FT Status LED do not illuminate or illuminate amber
”
of this
chapter to start the HAS Fault Tolerance service and retry disconnecting the I/O module.
Source: HasCtrl
Type: Warning
Event ID: 1506
Description: The doubleness information about an I/O device is not reported.
Unavailable disks are displayed on Disk Management:
Follow the instruction below:
Disk Status Description Action
A message [Foreign] is
displayed when the dynamic
disk used on another system is
mounted. [To use data of the disk]
Import the disk referring to Chapter 3
“
Windows Setup
and Operation
”
.
[To make the disk usable]
Initialization is required to use this disk. Initialize this
disk to convert it to a usable disk.
<Note>
The data on disks are lost when initialized. Make sure to
back up the data before initializing disks.
A message [Missing] is
displayed when the dynamic
disk is broken or removed. Delete the mirror on the disk when mirror volume is on
missing disk.
After deleting the mirror, right-click [Missing] disk and
execute [Remove disk].
A message
[Not Initialized] is displayed
when there is no signature on
the disk. Right-click on the disk and execute [Initialize Disk] to
convert it to a usable disk.
DISK ACCESS LED is amber and blinking:

Is the mirror of the hard disk not removed?

Check [Disk Management], and reconfigure the mirror if the mirror is broken.
(See
“
Configuring and Breaking Mirror
”
in Chapter 3
“
Windows Setup and Operation
”
.)
Relevant Disk LED and DISK ACCESS LED light amber during the process of automatic mirror
reconfiguration. During the process of reconfiguration, DISK ACCESS occurs at the same time, and
amber and green appear to light alternately. Wait for a while if it is found out that the mirror is being
reconfigured in
“
Disk Management
”
, etc.
When one of the disks that configure the mirror is broken, the other disk becomes
“
Failed
Redundancy
”
. In this case, DISK LED also lights amber. Replace the failed disk and reconfigure the
mirror.
There are rare occasions when a mirrored volume is not fault tolerant even though the volume
’
s status
is displayed as Healthy. In that case, run [Reactive Disk].