© Munters AB, 2015
50
•
Time: Set event times for the lights.
o
On day 12, the center lights turn off, and the dimmer lights go to 45%. There are two
periods of darkness: from 01:00 to 03:00 in the morning, and 09:00 PM to midnight.
This program repeats until day 25.
o
From day 25 the on/off lights stay off, and the dimmer lights provide dim light during the
on periods, and go out fully for two periods of darkness. The dark periods total 6 hours,
being from midnight to 03:00 AM and from 08:00 PM (20:00) to 11:00 PM (23:00).
•
Light: Check mark the desired light(s) to turn on. Apply dots for lights you would like to turn off.
Switch between check marks and dots by pressing the +/- key.
•
Intensity (%): Set intensity in percentage for light dimmer(s). Dimmer lights start to brighten if
the intensity increases, and complete dimming if the intensity decreases at the set time. That is,
they start dimming the ‘sunset time’ in advance of the set time (see Help | Set below).
4.8.1
L
IGHT
H
ELP
|
S
ET
D
EFINITIONS
NOTE:
Pig Mode does not support Light Help parameters.
While viewing the Light menu:
Press
HELP
, select SET, and press
ENTER
.
•
Sunrise Time (minutes): The amount of time required for the light intensity to rise from 0% to the
designated level.
•
Sunset Time (minutes): The amount of time required for the light intensity to decline from the
designated level to 0%.
•
Allow Spiking from Day: The day spiking begins.
•
Spike Cycle (minutes): The time length that the spike is at its maximum level. Reaching the
maximum level and returning to the preset level both take one minute. For example if the spike
duration is 10 minutes, the spike cycle is 8 minutes.
•
Spike Durations (minutes): The total amount of time of the spike cycle, including the rise and
fall times.
•
Spike Increase Amount: Set the increase in intensity for the spike in relation to the current light
intensity.
•
Signal Light Is: Only one light operates during feeding times. Select which light is lit or choose
“None”.
NOTE:
After the feeding period ends, all lights selected in the Light Parameters screen relight.
•
Signal Before Feed (seconds): Amount of time, before the feeding starts, that all other lights
go off.
•
Signal During Feed (seconds): Amount of time that the selected light remains on after feeding
ends.
DEVICE SETTING
LIGHT
Sunrise Time (minutes)
Sunset Time (minutes)
Allow Spiking from Day
Spike Cycle (minutes)
Spike Duration (minutes)
Spike Increase Amount (%)
Signal Light Is:
Signal Before Feed (seconds)
Signal During Feed (seconds)
Light Sensor Active
10
10
1
0
0
0
LIGHT2
60
60
NO
