© Munters AB, 2015
36
o
Stop Value: Ammonia value at which to end treatment. Range: 0 to 100. Default: 2
o
Delay (Sec): When the ammonia level reaches the start value, the controller delays
treatment for this amount of time. Default: 0
o
Duration (Sec): Number of seconds the controller maintains the increased level of
ventilation. Default: 0
4. Set the Ammonia Alarm (page 72).
3.9.1
A
MMONIA
T
REATMENT
H
ELP
|
S
ET
D
EFINITIONS
While viewing the Ammonia Treatment menu: Press HELP, select SET, and press ENTER.
o
Ammonia Treatment below Heat: Select: Select YES or NO to enable Ammonia
Treatment when heaters are operating (set in Temperature Curve).
o
Ammonia Treatment By: This parameter designates the method used when ammonia
treatment begins. Normally, this parameter is relevant only when minimum ventilation is
running. When a treatment is required, select the method to be employed:
Level: Increases the ventilation level when a treatment is required.
NOTE:
When employing Ventilation by Weight, the controller increases the cycle time or the level,
depending on the particular settings.
Exhaust: Designate a specific exhaust fan (press a number key to select the fan).
Tunnel: Designate a specific tunnel fan (press a number key to select the fan).
None: Disables the treatment.
SYSTEM PARAMETERS
AMMONIA TREATMENT
Ammonia Treatment Below Heat
Ammonia Treatment By
No
Level
