MKS GMW-25, Руководство по эксплуатации

Страница: 77 / 98

Operation
GMW-25 3-19
3.2.5 MATCHWORK
®
Readback via the Generator
These commands are used to cause information to be read back from
the MATCHWORK. Commands that show the optional dash parameter
<-> can read back continuously if this option is used. Pressing the ESC
key, or sending an escape character (1Bh) will break the continuous
loop.
Command Options Description
POW <->
Causes the forward power through the MATCHWORK to be
returned.
RCO Causes the C1 capacitor position to be read back. A value for
0-999 will be returned representing the percentage (0-99.9%) of
the full tuning range of the capacitor.
RCT Causes the C2 capacitor position to be read back. A value for
0-999 will be returned representing the percentage (0-99.9%) of
the full tuning range of the capacitor.
RDC <-> Causes the DC Bias value to be returned (calibrated in Volts).
RMG <-> Causes the magnitude error at the input of the MATCHWORK to
be returned.
ROT <=> Returns the amount of time that RF has been passed through
the MATCHWORK. If ROT is typed alone, the value returned is
the amount of time in hours only. If the <=> option is used, the
value returned will be in the HH.MM.SS format.
RPH <-> Causes the phase error at the input of the MATCHWORK to be
returned.
RPP <-> Causes the peak-to-peak voltage measured at the output stud
to be returned. This command is only useful if the optional Vpp
circuit is installed in the controller unit. If the circuit is not
installed, random values may be returned.
RUT <=> Returns the amount of time the MATCHWORK has been
powered on. If RUT is typed alone, the value returned is the
amount of time in hours only. If the <=> option is used, the
value returned will be in the HH.MM.SS format.
MATCHWORK Readback Commands
Table 3.2.5
Note: The Matching Network needs to be connected to the generator per Figure 2.6 and set
up according to section 3.1.3.