MKS GMW-25, Руководство по эксплуатации

Страница: 71 / 98

Operation
GMW-25 3-13
3.2.1 Basic Monitor
The basic monitor commands allow the user limited access to the
Controller software.
Command Option Description
HEL <n> Decimal values of n from 0 to 9 display each of the ten possible
help screens. Any value of n outside this range will show help
screen 0.
CHK The result of this command is the display of the software
checksum. This checksum will be calculated each time the CHK
command is initiated.
IDE <ident> The ident may have values from 0 to 255. This command works
in association with the generator's RS422 address. When the
ident in the command is the same as the address in an RS422
configured generator, it is possible to communicate with the DSP.
If the ident does not match the address, communication is
disabled. This command is designed to work only while
communicating on an RS422 bus.
EKO <n> This command sets the echo mode of the digital communications.
While in echo mode, all characters sent to the generator via the
serial link are echoed back down the link to the sender.
n = 0 turns echo mode on (characters are echoed)
n = 1 turns echo mode off (characters are not echoed)
*NOTE: When echo mode is off, though characters are not seen
on a terminal as they are typed, they are indeed being sent to the
generator.
Basic Monitor Commands
Table 3.2.1
* These commands are available in version 1.1 of the software and any
versions that follow it.