MKS GMW-25, Руководство по эксплуатации

Страница: 73 / 98

Operation
GMW-25 3-15
3.2.3 Generator Readback
These commands are used to read back operating status information
on the generator. Commands that show the optional dash parameter
<-
> can read back continuously if this option is used. Pressing the ESC
key, or sending an escape character (1Bh) will break the continuous
loop.
Command Option Description
ACT < - > The result of this command is the display of power set point,
forward power, reverse power, PSU voltage, and output frequency.
When a dash is present in the command (ACT-), this result will be
updated continuously until the escape key is sent.
PAI < - > The result of this command is the display of the Current through the
PA of the generator.
When a dash is present in the command (PAI-), this result will be
updated continuously until the escape key is sent.
PAV < - > The result of this command is the display of the Voltage rail of the
generator’s PA.
When a dash is present in the command (PAV-), this result will be
updated continuously until the escape key is sent.
RFV < = > The result of this command is a 16-bit integer. Each bit in this
integer represents a fault. If a bit is set, then the fault condition that
is associated with that bit exists.
When this command is specified with the equal sign (RFV=), each
fault that exists is displayed in a more verbose manner, one fault
per line.
BIT FAULT DESCRIPTION
0. RF Overheat
1. Fan Fault
2. Driver Fault
3. PSU Voltage Limit
4. Forward Power Limit
5. Reverse Power Limit
6. PSU Current Limit
7. Dissipation Power Limit
8. Link Integrity Fault
9. Failed Ignition
10. Undefined
11. Undefined
12. Undefined
13. Undefined
14. Undefined
15. Undefined
ROD < - > The result of this command is the display of the dissipated power.
When a dash is present in the command (ROD-), this result will be
updated continuously until the escape key is sent.