Mitsubishi MOTORS SHOGUN SPORT, Руководство пользователя

Страница: 149 / 501

Warning lamps
5-52 Instruments and controls
5
E00509901382
This indicator lamp illumi-
nates when the ignition switch
is turned to the “ON” position
or the operation mode is put in
ON, and goes off after the
engine has started. If it lights up while the
engine is running, it indicates that water has
accumulated inside the fuel filter; if this hap-
pens, take action as follows.
Remove the water from the fuel filter. Refer
to “Removal of water from the fuel filter” on
page 8-5.
When the lamp goes out, you can resume
driving. If it either does not go out or comes
on from time to time, we recommend you to
have the vehicle inspected.
E00502400147
E00502503918
This lamp illuminates when
the ignition switch is turned to
the “ON” position or the oper-
ation mode is put in ON, and
goes off after a few seconds.
Always make sure that the lamp goes off
before driving.
With the ignition switch or the operation
mode in ON, the brake warning lamp illumi-
nates under the following conditions:
 When the parking brake has been applied.
 When the brake fluid level in the reservoir
falls to a low level.
 When the brake force distribution func-
tion is not operating correctly.
With the ignition switch or the operation
mode in ON, a buzzer sounds under the con-
dition that the vehicle speed exceeds a certain
speed with the parking brake applied.
CAUTION
 If the diesel preheat indicator lamp comes on
after the engine is started, the engine speed
may not rise above the idling speed because
of fuel freezing. In this case, keep the engine
idling for approximately 10 minutes, then
turn off the ignition switch or put the opera-
tion mode in OFF and immediately turn it on
or put in ON again to confirm that the diesel
preheat indicator lamp is off.
NOTE
 If the engine is cold, the diesel preheat indi-
cator lamp is on for a longer time.
 [Except for vehicles equipped with the key-
less operation system]
When the engine has not been started within
approximately 5 seconds after the diesel pre-
heat indicator lamp went out, return the igni-
tion switch to the “LOCK” position. Then,
turn the switch to the “ON” position to pre-
heat the engine again.
 When the engine is warm, the diesel preheat
indicator lamp does not come on even if the
ignition switch is turned to the “ON” posi-
tion or the operation mode is put in ON.
Fuel filter indicator lamp (die-
sel- powered vehicles equipped
with the multi information dis-
play - type 2) Warning lamps
Brake warning lamp (red)
BK0240501EN.book 52 ページ ２０１６年１１月１０日 木曜日 午前１０時３５分