Mitsubishi MOTORS SHOGUN SPORT, Руководство пользователя

Страница: 71 / 501

Seat belts
4-16 Seat and seat belts
4
E00409802332
If the ignition switch is turned to the “ON”
position or the operation mode is put in ON
while the driver’s and/or the front passenger’s
(if so equipped) seat belt is not fastened, the
warning lamp comes on and the tone sounds
for approximately 6 seconds to remind the
driver and/or the front passenger (if so
equipped) to fasten the seat belt.
If the vehicle is driven with the seat belt still
unfastened, the warning lamp will blink and
the tone will sound intermittently until the
seat belt is fastened. At the same time, “FAS-
TEN SEAT BELT” is displayed on the infor-
mation screen in the multi information
display (Type 1 only).
E00405001704
The seat belt anchor height can be adjusted.
To move the anchor, pull the lock knob (A)
and slide the anchor to the desired position.
Release the lock knob to lock the anchor into
position.
NOTE
 As the belt retracts automatically, keep the
latch plate held while retracting so that the
belt stows slowly. Failure to do this could
damage the vehicle.
 If the seat belt (A) or ring (B) becomes dirty,
the belt may not retract smoothly. If the seat
belt and ring are dirty, clean them with a
mild soap or detergent solution.
Seat belt reminder
*
Type 1
Type 2
WARNING
 Do not install any accessory or sticker that
makes the lamp difficult to see.
NOTE
 If the seat belt subsequently remains unfas-
tened, the warning lamp and the tone will
issue further warnings each time the vehicle
starts moving from a stop.
 For the front passenger seat, the warning
function works only while a person is sitting
on the seat.
 When luggage is placed on the front passen-
ger seat, a sensor in the seat cushion may,
depending on the weight and position of the
luggage, cause the warning tone to sound
and the warning lamp to come on.
Adjustable seat belt anchor
(front seats)
BK0240501EN.book 16 ページ ２０１６年１１月１０日 木曜日 午前１０時３５分