Mitsubishi MOTORS SHOGUN SPORT, Руководство пользователя

Страница: 460 / 501

Replacement of lamp bulbs
Maintenance 10-27
10
E01003102046
Before replacing a bulb, ensure the lamp is
off. Do not touch the glass part of the new
bulb with your bare fingers; the skin oil left
on the glass will evaporate when the bulb gets
hot and the vapor will condense on the reflec-
tor and dim the surface.
E01003201431
When replacing a bulb, use a new bulb with
the same wattage and colour.
CAUTION
 If the newly inserted fuse blows again after a
short time, have the electrical system
checked by an authorised MITSUBISHI
MOTORS dealer to find the cause and rec-
tify it.
 Never use a fuse with a capacity larger than
that specified or any substitute, such as wire,
foil, etc.; doing so will cause the circuit wir-
ing to heat up and could cause a fire.
Replacement of lamp bulbs
CAUTION
 Bulbs are extremely hot immediately after
being turned off.
When replacing a bulb, wait for it to cool
sufficiently before touching it. You could
otherwise be burnt.

Handle halogen lamp bulb with care. The gas
inside halogen lamp bulb is highly pressur-
ized, so dropping, knocking, or scratching a
halogen lamp bulb can cause it to shatter.
 Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the bulb
to break the next time the headlamps are
operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc., and
refit it after drying it thoroughly.
 Do not install commercially available LED-
type bulbs.
Commercially available LED-type bulbs
could adversely affect the operation of the
vehicle, such as by preventing the lamps and
other vehicle equipment from operating
properly.
NOTE
 If you are unsure of how to carry out the
work as required, it is recommended that
these procedures be carried out by an author-
ised MITSUBISHI MOTORS dealer.

Be careful not to scratch the vehicle body
when removing a lamp or lens.
 When it rains, or when the vehicle has been
washed, the inside of the lens sometimes
becomes foggy. This is the same phenome-
non as when window glass mists up on a
humid day, and does not indicate a functional
problem. When the lamp is switched on, the
heat will remove the fog. However, if water
gathers inside the lamp, please go to an
authorised MITSUBISHI MOTORS dealer
for a check.
Bulb location and capacity
BK0240501EN.book 27 ページ ２０１６年１１月１０日 木曜日 午前１０時３５分